• Xilinx ISE® 10.1 or higher must be installed.
  • Download this from the Software Updates page if you have not already done so.
  • You must be registered on Xilinx.com to access this service pack

Simulation Only Evaluation allows you to customize the core through a CORE Generator™ customization GUI and generate a Simprim gate level model for functional simulation. To perform a Simulation Only Evaluation:

• Make sure you have satisfied the requirements listed at the top of this page.
• Download ISE v10.1 from the Software Updates page
• Registration is required before downloading the service pack.
• If you have not registered, you will be given the opportunity to do so when you click to download the updates.
• Follow the installation instructions in the Release Notes for this product.
• Start up the CORE Generator using either of the following two methods:
  • From ISE: Select Projects -> New Source -> IP (Coregen and Architecture Wizard)
  • From Windows: Select Programs -> Xilinx -> Accessories -> CORE Generator
• To access the core, double click on the "Communication & Networking" folder in the left hand panel of the CORE Generator GUI, then double click on the "Ethernet" folder.
• Double click on the Ethernet 1000BASE-X PCS/PMA or SGMII core to call up the IP customization GUI.

Since the Xilinx Ethernet 1000BASE-X PCS/PMA or SGMII standalone LogiCORE is provided free of charge to all licensed Xilinx ISE customers, there is no "Full System Hardware Evaluation" version available.

Please register to download the full release core here.