AR# 50875


Zynq-7000 SoC ZC702 Evaluation Kit - Why does my board not have the SW16 switch as shown in the User Guide?


(UG926), Zynq-7000 SoC ZC702 Evaluation Kit Getting Started Guide, lists SW16 as the five-position DIP switch used to set the configuration mode.

My ZC702 does not show this SW16 - why is that?


SW16 (light blue / grey 5-position DIP switch) is present on Rev D and later revisions of ZC702, as shown below:

Earlier revisions of the ZC702 Evaluation Kit, such as Rev B or Rev C, do not have this DIP switch present. 

Instead, the mode is set using the jumpers immediately below the FMC headers as shown below:

These are jumpers J20, J21, J22, J25 and J26.

The jumpers correspond to the settings in SW16 as follows:


Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
47864 Zynq-7000 SoC ZC702 Evaluation Kit - Known Issues and Release Notes Master Answer Record N/A N/A
AR# 50875
Date 05/17/2018
Status Active
Type General Article
Boards & Kits
People Also Viewed